61 67 083 Removing and installing / replacing left or right high-pressure nozzle of headlight washer system

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

13 3 010

Necessary preliminary tasks:

Remove Front Bumper Trim

To prevent excessive escape of washer fluid, seal off end of high-pressure line with special tool 13 3 010.

Fig 1: Identifying Special Tool (13 3 010)

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock catch (1) in direction of arrow.

Remove high-pressure nozzle (2) towards rear from headlight arm (3).

Unlock high-pressure line and detach from high-pressure nozzle.

Installation:

Keep plug connection for high-pressure nozzle (2) and high-pressure line clean and free from grease.

Fig 2: Identifying High-Pressure Nozzle, Headlight Arm, Catch And Removal Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Ensure that guide (2) is correctly seated.

Make sure retaining lugs (1) engage correctly.

Carry out a function test before fitting bumper trim.

If necessary, adjustment can be carried out carefully using pointed pliers (tape of front area with adhesive tape where necessary).

Fig 3: Identifying Retaining Lugs And Guide

Courtesy of BMW OF NORTH AMERICA, INC.