51 61 017 Removing and installing/replacing diagonal strut, front end, left (convertible)
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Scalding hazard!
Only perform work after engine has cooled down.
Only perform work after engine has cooled down.
IMPORTANT:
Observe SAFETY INSTRUCTIONS
for raising the vehicle.
Driving without the diagonal strut is not permitted!
Driving without the diagonal strut is not permitted!
Necessary preliminary tasks:
- Remove front underbody protection for RWD or AWD
- If necessary, remove RADIATOR SEAL
- N51, N52, N53: Remove INTAKE FILTER HOUSING
IMPORTANT:
Diagonal strut on right side must be installed in direction of travel ahead of diagonal strut on left side.
Release screws (1) and nuts (2).
Feed out diagonal strut (3) towards top.
Installation:
Replace screws.
Replace self-locking nut.
- Nut
Tightening torque: 56 Nm
- Screw
Tightening torque: 56 Nm
Angle of rotation: 90°