51 61 011 Removing and installing/replacing V-strut, front axle carrier, left or right (convertible)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle.
Driving without the V-strut is not permitted!

Necessary preliminary tasks:

Remove front underbody protection for RWD or AWD

Release screws (1, 2, 3).

Remove V-strut (4) towards front.

Installation:

Replace screws.

Make sure bolts are installed in correct positions.

Screw (1) M8x55
Screw (2) M8x35
Screw (3) M10x35

Tightening torque: see 10 AZ in 51 71 SEALS AND LOOSE BODY PARTS ..

Fig 1: Identifying V-Strut And Screws

Courtesy of BMW OF NORTH AMERICA, INC.