Removing Wheel Arch

Mark severance cut (1) in front of holder (2) and cut (holder (2) remains on vehicle).

Open welded connections in area (3).

Installation note: 

Mark severance cut (1) in on new part and cut. Take off holder (2).

Apply sealant to cavity acoustic baffle (4). See (expanded)  or (not expanded) .

Fig 1: Severance Cut With Sealant And Welding Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Open welded connections in areas (1).

Fig 2: Welding Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Open welded connections in area (1).

Fig 3: Welding Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Open welded connections in area (1).

Installation note: 

If equipment compartment partition wall (2) is damaged, cut along line (3).

Mark new part in accordance with severance cut on vehicle + 20 mm extra material and cut.

Bond both parts overlapping and rivet. Depending on accessibility, use punch rivets N4 and blind rivets N3.

Fig 4: Welding Areas On Compartment Partition Wall

Courtesy of BMW OF NORTH AMERICA, INC.

Open welded connections in area (1).

Fig 5: Welding Areas

Courtesy of BMW OF NORTH AMERICA, INC.