41 21 510 Front Left Door Pillar Replacement (Front Side Panel Removed) (Convertible)
Read contents of BODY, GENERAL .
For stripping and rigging operations, refer to FR number 41 21 510 .
Spot-weld bonding is used on this vehicle. Observe specific Procedure .
Remove or cover those vehicle components in the repair area which are susceptible to heat or dust.
Use only approved Spot-Welding Apparatus for repairs!
Place vehicle on straightening bench.
Following new body parts are required:
- (1) Support carrier, wheel arch, outer
- (2) Side frame, outer
Mark severance cuts in accordance with specified measurements and cut.
Measurement a = approx. 130 mm from edge of rectangular hole.
Measurement b = approx. 160 mm from centerpoint of 12 mm dia. bore.
Open weld joints in areas (1).
Installation:
Weld in reinforcing panels at all severance cuts.
Mark severance cuts in accordance with specified measurements and cut.
Measurement a = approx. 175 mm from edge of cowl panel.
Dimension b = approx. 240 mm before bore hole dia. 20 mm.
Open weld joints in areas (1).
Open weld joints in areas (1).
Installation:
Mark new part in accordance with severance cuts above and cut.
Adjust new part to fit with straightening attachment or universal mount.
Weld in reinforcing panels at all severance cuts.