34 52 550 Removing and installing / replacing DSC sensor
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with Notes On Protection Against Electrostatic Damage (ESD Protection).
Necessary preliminary tasks:
- Remove left front seat
- Remove front left entrance cover strip
Lift carpet (1) and fold back to side.
Remove underlay (2).
Disconnect plug connection.
Installation:
Ensure proper locking of plug connector.
Slacken screws (3)
Release screws (4) and remove bracket with yaw sensor.
Installation:
For tightening torque refer to 34 51 3AZ in 34 51 SLIP CONTROL SYSTEM (DSC) .
When replacing DSC sensor:
Release screws (1) and modify DSC sensor (2).
Installation:
For tightening torque refer to 34 51 2AZ in 34 51 SLIP CONTROL SYSTEM (DSC) .