32 11 100 Replacing gaiter for steering box on left or right

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The power steering gear must be replaced if the polished surface of the rack is damaged (e.g. by corrosion)!

Necessary preliminary tasks:

Remove front assembly underside protection

Clean tie rod.

Release band clamp (1).

Mark screw-in depth of tie rod (2) or count thread turns.

Release screw (3).

Twist tie rod (2) out of tie rod end (4).

Installation:

Replace microencapsulated screw.

For tightening torque refer to 32 21 2AZ in 32 21 STEERING ARMS, TIE RODS, STEERING DAMPER .

Fig 1: Clamp, Tie Rod, Screws, Bolt And Tie Rod End

G04726350

Courtesy of BMW OF NORTH AMERICA, INC.

Release ear clamp (1).

Detach gaiter (2) from tie rod (3).

Installation:

Clean rack and check surface for damage (e.g. by corrosion).

Grease rack (refer to OPERATING FLUIDS ).

Clean tie rod and apply grease to taper. This ensures that the gaiter is not rotated when the tie rod is rotated.

Fig 2: Ear Clamp, Gaiter, Tie Rod And Removal Direction

G04726351

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Perform chassis alignment check
Carry out steering angle sensor adjustment or adjustment for active front steering