11 53 000 Removing and installing/replacing coolant thermostat (N51)

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Danger of scalding!

Only perform this work after engine has cooled down.

Recycling

Catch and dispose of drained coolant in a suitable container.

Observe country-specific waste-disposal regulations.

Necessary preliminary tasks:

Remove front splash guard
Drain Coolant from radiator.

Release hose clamp (1) and detach coolant hose.

Release hose clamp (2) and detach coolant hose.

Unlock and detach coolant hose (3).

Unlock and detach coolant hose (4).

Disconnect plug connection (5).

Release screws (6).

For tightening torque refer to 11 53 1AZ in 11 53 COOLANT THERMOSTAT WITH CONNECTIONS .

Remove coolant thermostat (7).

NOTE: Illustration shows coolant thermostat removed.

Fig 1: Hose Clips, Hoses, Screws, Coolant Thermostat And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Venting Instructions must be observed without fail.