16 11 060 Removing and installing or replacing fuel filler pipe

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2008 BMW 328xi, 2008 BMW 328i, 2008 BMW 323i, 2007 BMW 328xi, and 2007 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Unhook retaining strap (1) from tank flap.

Open cap and set to one side.

Fig 1: Identifying Tank Flap Retaining Strap

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten hose clip (4).

Installation:

Replace hose clip.

For tightening torque refer to 16 12 1AZ in 16 12 FUEL DELIVERY .

Fig 2: Identifying Fuel Tank Hose Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock quick-release fastener (1) and detach vent hose (2).

Unscrew nut (3).

Fig 3: Identifying Fuel Tank Quick-Release Fastener, Vent Hose And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Installation:

For tightening torque refer to 16 12 2AZ in 16 12 FUEL DELIVERY .

Withdraw fuel filler pipe (2) completely out of rubber gaiter at wheel arch and feed out.

Installation:

Make sure rubber gaiter is correctly seated.

Fig 4: Identifying Fuel Filler Pipe And Retaining Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clean contact surface on body and grounding lead on fuel filler pipe.

Ground connection must be guaranteed.