32 21 231 Replacing left or right tie rod
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2008 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove Tie Rod End From Swivel Bearing
- Remove Gaiter From Steering Gear and slide back
IMPORTANT:
To avoid damage to rack and to suspension mounting, move rack in as far as possible.
Release joint (1) with standard tool (38 WAF) from steering gear rack.
For tightening torque refer to 32 21 1AZ in 32 21 STEERING ARMS .
Installation:
Clean rack.
Check surface of rack for damage (e.g. corrosion).
Power steering gear only: Grease rack (refer to OPERATING FLUIDS ).
On replacement, assemble new part with gaiter:
- Determine measurement (A) to simplify following adjustment of front axle.
Installation:
Slacken clamping screw (1) and screw off tie rod end.
Push clamp and gaiter onto tie rod.
Screw in tie rod end to measurement (A).
For tightening torque refer to 32 21 2AZ in 32 21 STEERING ARMS .
After installation:
- Perform Chassis Alignment Check
- Carry out Steering Angle Sensor Adjustment