32 21 151 Replacing left or right tie rod
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2008 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If the tie rod end to tie rod screw/bolt connection is released, it is necessary after reinstallation to carry out a wheel/chassis alignment check.
Necessary preliminary tasks:
- Remove Front Wheel
IMPORTANT:
Do not release tie rod end from swivel bearing with impact tool.
Rubber gaiter of tie rod end must not be damaged!
Release nut (1); if necessary, grip at Torx socket.
Remove tie rod end (2) from swivel bearing.
Installation:
Keep tie rod end to swivel bearing connection clean and free from oil and grease.
Replace self-locking nut.
For tightening torque refer to 32 21 3AZ in 32 21 STEERING ARMS .
Determine measurement (A) to simplify following adjustment of front axle.
Release screw (1).
Screw off tie rod end; if necessary, grip tie rod with open-end wrench.
Installation:
Check Gaiter for damage, replace if necessary.
Screw in tie rod end to measurement (A).
For tightening torque refer to 32 21 2AZ in 32 21 STEERING ARMS .
After installation:
- Perform Chassis Alignment Check
- Carry out Steering Angle Sensor Adjustment