33 55 021 Replacing both rubber mounts for stabilizer mounting
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 335i, 2008 BMW 328i, 2008 BMW 323i, 2007 BMW 335i, and 2007 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove Rear Wheel.
Release screws (1).
For tightening torque refer to 33 55 1AZ in 33 55 STABILIZER BAR .
Remove retaining bracket (2) and rubber mount (3).
Installation:
Keep retaining bracket (2), rubber mount (3) and stabilizer clean and free from oil and grease.
Clean rear stabilizer on both sides.
Position rubber mount on rear stabilizer.
Position retaining bracket on rubber mount.
Push rubber mount with retaining bracket on rear stabilizer to installation position.