LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1070 (Rear Axle - Repair - E90/E91) >> 10 Final drive >> 33 10 ... Removing and installing/replacing vibration damper

33 10 ... Removing and installing/replacing vibration damper

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 335i, 2008 BMW 328i, 2008 BMW 323i, 2007 BMW 335i, and 2007 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Variant A: 

Release screw (1).

For tightening torque refer to 33 17 2AZ in 33 17 REAR AXLE DIFFERENTIAL MOUNTINGS .

Remove vibration damper (2).

Fig 1: Identifying Vibration Damper And Mounting Screw
G04726442Courtesy of BMW OF NORTH AMERICA, INC.

Variant B: 

Release bolt (1) and remove vibration damper (2).

For tightening torque refer to 33 17 3AZ in 33 17 REAR AXLE DIFFERENTIAL MOUNTINGS .

Fig 2: Identifying Vibration Damper And Mounting Bolt
G04726443Courtesy of BMW OF NORTH AMERICA, INC.

Variant C: 

NOTE: Removal depicted on left vibration damper.

Release bolt (1) and remove vibration damper (2).

For tightening torque refer to 33 17 3AZ in 33 17 REAR AXLE DIFFERENTIAL MOUNTINGS .

Fig 3: Identifying Left Vibration Damper And Mounting Bolt
G04726444Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals