41 5.... Front Side Doors Removal And Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not damage adjoining body parts.

The illustrations are schematic representations and are to be applied to the relevant vehicle type.

Open door.

Release screw on connector frame.

Front door:

For tightening torque refer to 41 51 4AZ.

Rear Door:

For tightening torque refer to 41 52 4AZ.

Fig 1: Locating Screw On Connector Frame

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Secure door against closing.

Release screw (1) on door retainer.

Front door:

For tightening torque refer to 51 21 3AZ.

Rear Door:

For tightening torque refer to 51 22 3AZ.

Fig 2: Identifying Door Retaining Screw

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Secure door against falling out.

Release screws between both hinge elements at top and bottom.

Pull both screws out of hinges.

Front door:

For tightening torque refer to 41 51 1AZ.

Rear Door:

For tightening torque refer to 41 52 1AZ.

Fig 3: Identifying Release Screws Between Hinge Elements

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out door sideways and place it on a suitable surface.

Fig 4: Removing Door Sideways

Courtesy of BMW OF NORTH AMERICA, INC.

Pull plug connection from door pillar, unlock by pulling out bar and detach.

Installation:

If necessary, Adjust Door .

Fig 5: Removing Plug Connection From Door Pillar

Courtesy of BMW OF NORTH AMERICA, INC.