51 43 075 Removing and installing / replacing side trim panel, footwell, on A-pillar, right

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317

Necessary preliminary tasks:

Remove Front Entrance Cover Strip (Inside)

Except on E87:

Remove Trim For Instrument Panel, Bottom Left

Detach mucket (1) in area of side trim panel (2).

Unclip side trim panel (2) with special tool 00 9 317 in direction of arrow at retaining points (3) and remove.

Fig 1: Identifying Mucket. Side Trim Panel, Retaining Points And Special Tool (00 9 317)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clips (1) remaining in bores.

If necessary, replace faulty clips (1).

Position side trim panel (2) preinstalled with clips (1) on associated bores and clip into place.

Fig 2: Identifying Clips And Side Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.