52 14 060 Removing and installing/replacing valve housing for lumbar cushion

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove Rear Panel On Front Seat

Detach backrest cover (1) from backrest frame.

Fig 1: Identifying Front Seat Backrest Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Remove valve housing (2) for lumbar support in direction of arrow from backrest frame.

Installation:

Check valve housing for correct seating in backrest frame.

Fig 2: Identifying Valve Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Unlock quick connector and detach air hoses (3) and (4 and 5) from valve housing (2).

Valve unit for lumbar support:

(3) Hose (clear), lumbar drive
(4) Hose (blue), top lumbar cushion
(5) Hose (red), bottom lumbar cushion
NOTE: Connections are coded against incorrect assembly.

Fig 3: Identifying Plug Connection, Air Hoses And Valve Housing
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Carry out Function Check.