52 13 040 Removing and installing/replacing outer cover on left or right front seat backrest (normal / manual)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317

Necessary preliminary tasks:

Remove Front Seat

Raise lock (3) and lever out handle

for backrest angle adjustment and
for seat height adjustment

with special tool 00 9 317.

Fig 1: Identifying Seat Lever Lock, Back Rest Adjustment And Seat Height Adjustment Levers

G04727017

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

'For tightening torque refer to 52 10 06AZ in 52 10 FRONT SEATS .

NOTE: Trim (2) is engaged in marked area.
Press lock (3) and pull trim (2) off seat mechanism.

If necessary, lever out carefully with special tool 00 9 317.

Fig 2: Identifying Seat Trim, Lock And Retaining Bolt

G04727018

Courtesy of BMW OF NORTH AMERICA, INC.

Model with lumbar supports:

Unfasten plug connection (1) and disconnect.

Fig 3: Identifying Lumbar Support Plug Connection

G04727019

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only:

Unlock catches (1) on left and right and remove switch (2) from trim (3).

Fig 4: Identifying Seat Catches, Switch And Trim

G04727020

Courtesy of BMW OF NORTH AMERICA, INC.