52 13 000 Removing and installing left or right front seat (normal / manual)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove Front Head Restraint

WARNING: Read and comply with Safety Regulations for handling airbag modules and pyrotechnical belt tensioners.

Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.

Switch off ignition.

Lever out trim (1) for belt anchor fitting with plastic wedge.

Fig 1: Identifying Belt Anchor Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque value 44Nm.

Remove anchor fitting (2).

Installation:

Make sure anchor fitting (2) is correctly seated on seat mechanism pin.

Fig 2: Identifying Belt Anchor Fitting And Mounting Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Installation:

Replace screws.

For tightening torque refer to 52 10 1AZ in 52 10 FRONT SEATS .

Move front seat as far back as possible.

Fig 3: Identifying Front Seat Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (3).

Installation:

Replace screws.

For tightening torque refer to 52 10 1AZ in 52 10 FRONT SEATS .

Unlock plug connection (1) and disconnect plug (2).

IMPORTANT: Cover door sill with protective covers (risk of damage).

Lift out front seat.

Fig 4: Identifying Plug Connection, Retaining Screws And Plug Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Carpet must not get between seat rails and floor pan in area of fastening points (grating noises).