61 67 083 Removing and installing / replacing left or right high-pressure nozzle of headlight washer system
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 13 3 010
Necessary preliminary tasks:
- Remove Front Bumper Trim
To prevent excessive escape of washer fluid, seal off end of high-pressure line with special tool 13 3 010.
Unlock catch (1) in direction of arrow.
Remove high-pressure nozzle (2) towards rear from headlight arm (3).
Unlock high-pressure line and detach from high-pressure nozzle.
Installation:
Keep plug connection for high-pressure nozzle (2) and high-pressure line clean and free from grease.
Installation:
Ensure that guide (2) is correctly seated.
Make sure retaining lugs (1) engage correctly.
Carry out a function test before fitting bumper trim.
If necessary, adjustment can be carried out carefully using pointed pliers (tape of front area with adhesive tape where necessary).