61 12 004 Replacing battery positive lead (from luggage compartment connector to engine bulkhead connector)

Necessary preliminary tasks: 

• Remove Battery 
• E93 only: 

  Remove vibration damper

Open cap (1) and release nut underneath.

For tightening torque refer to 61 12 1AZ in 61 12 AUXILIARY CABLES/LEADS .

Remove cable lug mounting from positive battery leads (2).

Fig 1: Identifying Positive Battery Leads And Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Turn clamping rings (1) in direction of arrow and remove.

Installation: 

Make sure clamping rings (1) are correctly seated.

Fig 2: Identifying Battery Clamping Rings

Courtesy of BMW OF NORTH AMERICA, INC.

Remove Right Underbody Panelling.

Remove Fuel Tank.

Pull battery positive lead (1) out of luggage compartment floor (2).

Fig 3: Identifying Battery Positive Lead And Luggage Compartment Floor

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Remove cover (2) and release cable holder.

Fig 4: Identifying Mounting Screw And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release cable holder (1).

Fig 5: Identifying Battery Cable Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Remove Electronics Box.

Remove protective cap (1).

Release nuts underneath.

For tightening torque refer to 61 12 4AZ in 61 12 AUXILIARY CABLES/LEADS .

Remove positive battery cable.

Fig 6: Identifying Battery Cable Protective Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Remove front right Wheel Arch Cover (Rear Section).

Release cable strap (1).

Remove battery positive lead in downward direction.

Fig 7: Identifying Battery Cable Strap

Courtesy of BMW OF NORTH AMERICA, INC.