64 11 806 Removing and installing/replacing servodrive for fresh-/recirculated-air flap

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2008 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Servomotors must be re-addressed in the event of replacement!

Addressing can only be carried out with the BMW diagnosis system.

Service functions:

Body
Heating and A/C function
Flap motors
Re-address flap motors

Necessary preliminary tasks:

Remove Right Glovebox With Housing

Unfasten plug connection (1) and disconnect.

Release screws (2).

Detach servodrive for fresh-/recirculated-air flap (3) in direction of arrow from heater/air conditioner.

Installation:

Place servodrive for fresh-/recirculated-air flap (3) exactly on associated gear teeth.

Fig 1: Identifying Fresh-/Recirculated-Air Flap Servodrive, Mounting Screws And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.