67 62 000 Removing and installing/replacing flat motor for front left or right power window unit
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove Power Window Unit in front door.
Release screws (1).
For tightening torque refer to 67 62 1AZ in 67 62 DRIVES, POWER WINDOWS .
Detach flat motor for power window unit (2) from power window unit and remove.
Installation:
Fit flat motor for power window unit (2) exactly on teeth of power window unit.
Carry out function check (one-touch function, anti-trapping protection and, if necessary, comfort function).
Replacement:
A normalization must be carried out in order to activate anti-trapping protection.
Operating sequence for normalization:
- Operate corresponding power window switch in "Close" setting.
- Once the upper end position has been reached, hold power window switch down for approx. 1 second more.
Normalization is thus completed.