31 35 007 Removing and installing/replacing holder for left or right push rod/stabilizer

WARNING: This page is about a different car, the 2010 BMW 535i, 2009 BMW 535i, and 2008 BMW 535i. However, it is still accessible from the selected car via links, so may be relevant.

Remove FRONT WHEEL .

Remove STABILIZER LINK from holder (1).

Release screw (2).

Tightening torque 31 35 10AZ .

Fig 1: Identifying Stabilizer Link Holder And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Support swivel bearing with workshop jack and a suitable mounting.

Unscrew nut (1).

Remove holder (2) for brake hose, pulse generator and if necessary brake pad sensor.

Remove screw (4) with holder (3) towards front.

Installation:

Replace self-locking nut.

Tightening torque 31 31 3AZ .

Fig 2: Identifying Holder, Nut And Screw

Courtesy of BMW OF NORTH AMERICA, INC.