31 35 005 Removing and installing/replacing push rod (stabilizer link) for left/right stabilizer
WARNING: This page is about a different car, the 2010 BMW 535i, 2009 BMW 535i, and 2008 BMW 535i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Stabilizer links may only be replaced in pairs.
Necessary preliminary tasks:
- Remove FRONT WHEEL
Release nuts (1, 2); if necessary, grip at Torx socket.
Remove stabilizer link.
Installation:
Replace self-locking nuts.
Tightening torque 31 35 11AZ .