31 10 010 Removing and installing/replacing reinforcement plate

WARNING: This page is about a different car, the 2010 BMW 535i, 2009 BMW 535i, and 2008 BMW 535i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle
Driving without reinforcement plate is not permitted!

Necessary preliminary tasks:

Remove underbody protective plate. See REMOVING AND INSTALLING / REPLACING FRONT UNDERBODY PROTECTION or REMOVING AND INSTALLING/REPLACING REAR UNDERBODY PROTECTION

Release screws (1) and remove reinforcement plate.

Installation:

Replace screws and insertion nuts.

Tightening torque 31 10 9AZ .

Fig 1: Identifying Reinforcement Plate Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If applicable, remove heat shield.