31 10 Front Axle Suspension
WARNING: This page is about a different car, the 2010 BMW 535i, 2009 BMW 535i, and 2008 BMW 535i. However, it is still accessible from the selected car via links, so may be relevant.
FRONT AXLE SUSPENSION - TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Front axle carrier to engine carrier | E30, E31, E32, E34 | M10 8.8 | Replace screws (E30 AWD insert with Loctite) |
42 Nm |
| E30, E31, E32, E34 | M10 9.8 | Replace screws | 47 Nm | |
| E36 | M12 12.9 | Replace screws | 105 Nm | |
| E36, E46 | M12 10.9 | Replace screws | 110 Nm | |
| E38, E39 | M12 8.8 | Replace screws | 77 Nm | |
| E52 | M12 front 10.9 middle 8.8 rear 8.8 | Replace screws | 75 Nm | |
| E53, E60 / REAR END, E61 / REAR END, E63, E64, E65, E66, E67, E85, E86 | M12 10.9 | Observe repair instruction. | 100 Nm | |
| E60 / Four Wheel Drive, E61 / Four Wheel Drive | M12 10.9 | Observe repair instruction. Replace screws |
||
| Jointing torque | 100 Nm | |||
| Torque angle | 90° | |||
| 2AZ Front end of front axle carrier to body | E34 / Four Wheel Drive | M10 8.8 | 47 Nm | |
| E83 | M12 10.9 | 113 Nm | ||
| 3AZ Front axle subframe rear / middle to body | E34 / Four Wheel Drive | (collar screw) | 59 Nm | |
| E83 | M10 10.9 | 50 Nm | ||
| E83 | M12 10.9 | 100 Nm | ||
| 4AZ Front axle carrier with reinforcement to engine carrier | E31 | 47 Nm | ||
| 5AZ Cruciform reinforcement to door sill | E31 | 42 Nm | ||
| 6AZ Reinforcement to bracket Bracket to body |
E31 | 42 Nm | ||
| 7AZ Reinforcement (sleeve) to body | E31 | 127 Nm | ||
| 8AZ Front end reinforcement on front axle carrier/engine carrier | E46 | Replace screws; first tighten down rear screws | ||
| Jointing torque | 59 Nm | |||
| Torque angle | 90+30 ° | |||
| 9AZ Reinforcement plate to front axle support/engine carrier | E53 | Replace screws & nuts | ||
| Jointing torque | 56 Nm | |||
| Torque angle | 90° | |||
| E60 / REAR END, E61 / REAR END, E63, E64, E65, E66, E67 | Replace screws & insertion nuts | 56 Nm | ||
| Jointing torque | 56 Nm | |||
| Torque angle | 90° | |||
| E60 / Four Wheel Drive, E61 / Four Wheel Drive | Replace screws | |||
| Jointing torque | 56 Nm | |||
| Torque angle | 90° | |||
| E83 | M10 | Replace screws | 74 Nm | |
| 10AZ Adapter to body | E46 / Four Wheel Drive | Replace screws | 59 Nm | |
| 11AZ Front axle support to adapter | E46 / Four Wheel Drive | Replace screws | 110 Nm | |
| 12AZ Heat shield to front axle carrier | E60, E61, E63, E64, E65, E66, E67 | 8 Nm | ||
| 13AZ Mounting bracket to front axle carrier / engine carrier | E60 / Four Wheel Drive, E61 / Four Wheel Drive | M8 x 26 | 19 Nm |