64 11 800 Removing and installing/replacing servodrive for flap control gear (IHKA)
WARNING: This page is about a different variant/trim than selected.
Necessary Preliminary Tasks:
- Remove trim between front center console and instrument panel. Refer to 51 16 198 REMOVING/INSTALLING OR REPLACING TRIM BETWEEN FRONT CENTER CONSOLE AND INSTRUMENT PANEL .
- Remove radio receiver. Refer to 65 11 030 REMOVING AND INSTALLING/REPLACING RADIO RECEIVER (BUILT-IN UNIT) .
- Remove heater controls. Refer to 64 11 333 REMOVING AND INSTALLING/REPLACING HEATER CONTROLS (IHR AND IHKR) AND/OR 64 11 334 REMOVING AND INSTALLING/REPLACING HEATER CONTROLS (IHKA) .
- Release switch block on instrument panel. Refer to 61 31 059 REMOVING AND INSTALLING/REPLACING SWITCH BLOCK IN INSTRUMENT PANEL .
Unfasten plug connection (1) and disconnect.
Release screws (2) and remove servodrive for flap control gear.