31 35 021 Replacing both rubber mounts for anti-roll bar mounting on front axle support
WARNING: This page is about a different car, the 2010 MINI Cooper, 2009 MINI Cooper, and 2008 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove ANTI-ROLL BAR
IMPORTANT:
Circo Light must not
be used between anti-roll bar and rubber mount!
Remove retaining brackets (1).
Remove rubber mount (2) from anti-roll bar (2).
Installation note:
Keep anti-roll bar clean and free of oil and grease.
Make sure rubber mount (2) is correctly engaged on locating ring (3).
To install retaining bracket (1), coat rubber mount with Circo Light (sourcing reference: BMW Parts Service).