31 35 000 Removing and installing/replacing front anti-roll bar

WARNING: This page is about a different car, the 2010 MINI Cooper, 2009 MINI Cooper, and 2008 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Lower FRONT AXLE SUPPORT .

Release nut (1); if necessary, grip dihedron (2) or hexagon socket.

Tightening torque 31 35 1AZ

Installation note:

Replace self-locking nut.

Fig 1: Release Nut (1); If Necessary, Grip Dihedron (2) Or Hexagon Socket

Courtesy of BMW OF NORTH AMERICA, INC.

Release left and right screws (1).

Tightening torque 31 35 3AZ

Remove anti-roll bar (2) from control arm bracket.

Installation note:

Replace RUBBER MOUNT for anti-roll bar.

Fig 2: Identifying Anti-Roll Bar

Courtesy of BMW OF NORTH AMERICA, INC.