LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC - Climate Control System >> Removal And Installation >> Auxiliary Coolant Flow Pump >> Removal and Installation

Removal and Installation

  1. Drain the engine coolant. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  2. Remove the 3 auxiliary coolant flow pump bolts.
    • To install, tighten to 25 Nm (18 lb-ft).
  3. Disconnect the auxiliary coolant flow pump electrical connector.
  4. Release the 2 heater hose clamps and disconnect the 2 heater hoses from the auxiliary coolant flow pump.
  5. Remove the auxiliary coolant flow pump.
  6. To install, reverse the removal procedure.
  7. Fill the engine coolant level. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
scientia non olet · About LEMON Manuals