LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transaxle - AISIN Aw21) >> In-Vehicle Repair >> Manual Control Lever Shaft and Seal >> Removal

Manual Control Lever Shaft and Seal: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to REMOVAL AND INSTALLATION (2.5L), REMOVAL AND INSTALLATION (3.0L) and/or REMOVAL AND INSTALLATION .
  3. Remove the Air Cleaner (ACL) assembly. For additional information, refer to REMOVAL AND INSTALLATION .
  4. Disconnect the selector lever cable end.
    Fig 1: Locating Selector Lever Cable End
    G06269831Courtesy of FORD MOTOR CO.
  5. Disconnect the Transmission Control Module (TCM) electrical connector.
    Fig 2: Identifying TCM Electrical Connector
    G06264026Courtesy of FORD MOTOR CO.
  6. Remove the manual control lever nut.
    Fig 3: Locating Manual Control Lever Nut
    G06264027Courtesy of FORD MOTOR CO.
  7. Remove the manual control lever.
    Fig 4: Locating Manual Control Lever
    G06264028Courtesy of FORD MOTOR CO.
  8. Remove the bolts and remove the TCM  .
    Fig 5: Locating TCM & Bolts
    G06264029Courtesy of FORD MOTOR CO.
  9. Using a suitable pick, remove the manual control lever seal.
    Fig 6: Removing Manual Control Lever Seal
    G06264056Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals