Engagement Concerns: No Forward and/or No Reverse

WARNING: This page is about a different variant/trim than selected.

DIAGNOSTIC ROUTINES REFERENCE - ENGAGEMENT CONCERNS NO FORWARD AND NO REVERSE

Possible Component	Reference/Action
207 - ROUTINE
No Forward, No Reverse, No Forward or Reverse	-
Selector lever linkage damaged or out of position	Using a scan tool, check selector lever position. Refer to SELECTOR LEVER CABLE ADJUSTMENT -- AISIN AW21 .
Incorrect neutral switch position	Carry out neutral position learning. Refer to NEUTRAL POSITION LEARNING .
-	Disconnect the Transmission Control Module (TCM) electrical connector. If concern still exists, this indicates an internal mechanical problem. Connect the TCM and carry out pressure checks.
-	If concern is resolved by disconnecting the TCM , this indicates an electrical concern. Install a new TCM . Refer to Installation . Check wiring harness (external and internal) valve body connections. Inspect for damaged or broken halfshafts. Refer to FRONT DRIVE HALFSHAFTS .
Halfshafts broken