Selector Lever Cable Adjustment - Aisin AW21

Remove the Air Cleaner (ACL) assembly. For additional information, refer to REMOVAL AND INSTALLATION .
Disconnect the selector lever cable end from the manual control lever.

Fig 1: Locating Selector Lever Cable
Courtesy of FORD MOTOR CO.
Place the selector lever in DRIVE.

Fig 2: Identifying Selector Lever In DRIVE Position
Courtesy of FORD MOTOR CO.
Place the manual control lever in DRIVE.
1. Place the manual control lever in PARK.
2. Move the manual control lever counterclockwise 3 detents to the DRIVE position.
Fig 3: Identifying Manual Control Lever In PARK Position
Courtesy of FORD MOTOR CO.
Release the selector lever cable adjuster lock.
1. Pull out on the adjuster lock tabs.
2. Slide the lock up to unlock the selector lever cable.
Fig 4: Releasing Selector Lever Cable Adjuster Lock
Courtesy of FORD MOTOR CO.
Align the selector lever cable end to the manual control lever ball stud and install it with the adjuster unlocked.

Fig 5: Aligning Selector Lever Cable End To Manual Control Lever Ball Stud
Courtesy of FORD MOTOR CO.
Slide the adjuster tab in place to lock the selector lever cable.

Fig 6: Sliding Adjuster Tab
Courtesy of FORD MOTOR CO.
Install the ACL assembly. For additional information, refer to REMOVAL AND INSTALLATION .
Verify that the vehicle starts in PARK and NEUTRAL only and that the reverse lamps illuminate in REVERSE.