Pinpoint Test A: DTC B10D5:13

WARNING: This page is about a different variant/trim than selected.

A1 INSPECT THE PATS TRANSCEIVER FOR CORRECT INSTALLATION

NOTE: Replacement of the PATS transceiver does not require the PATS keys to be programmed into the Instrument Panel Cluster (IPC) again.

Ignition OFF.
Verify the PATS transceiver is correctly installed. Refer to Removal and Installation .
Ignition ON.
Clear the IPC DTCs.
Ignition OFF.
Ignition ON.
Retrieve the IPC DTCs.
Is DTC B10D5:13 retrieved?

Yes: INSTALL a new PATS transceiver. REFER to Removal and Installation . CLEAR the DTCs. CYCLE the ignition. REPEAT the self-test.
No: The system is OK.