LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Evaporative Emissions System (Hybrid)) >> Removal And Installation >> Fuel Vapor Tube Assembly >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to REMOVAL AND INSTALLATION - 2.5L, REMOVAL AND INSTALLATION - 3.0L and REMOVAL AND INSTALLATION - 3.5L .
  3. Remove the 3 nuts and the fuel tank filler pipe heat shield.
    • To install, tighten to 10 Nm (89 lb-in).
  4. Disconnect the Fuel Tank Pressure (FTP) sensor electrical connector.
  5. Disconnect the vapor blocking valve electrical connector.
  6. Disconnect the fuel vapor tube assembly-to-fuel tank quick connect coupling. For additional information, refer to QUICK CONNECT COUPLING .
  7. Disconnect the fuel vapor tube assembly-to-Evaporative Emission (EVAP) canister quick connect coupling. For additional information, refer to QUICK CONNECT COUPLING .
  8. Disconnect the fresh air tube (part of the fuel vapor tube assembly) from the fuel vapor separator and solenoid assembly.
  9. Release the pin-type retainer.
  10. Disconnect the fuel vapor tube assembly-to-recirculation tube quick connect coupling. For additional information, refer to QUICK CONNECT COUPLING .
  11. Remove the fuel vapor tube assembly.
  12. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals