Removal and Installation
WARNING: This page is about a different variant/trim than selected.
WARNING:
Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING:
Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING:
Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
- Disconnect the battery ground cable. For additional information, refer to REMOVAL AND INSTALLATION - 2.5L, REMOVAL AND INSTALLATION - 3.0L and REMOVAL AND INSTALLATION - 3.5L .
- Disconnect the Evaporative Emission (EVAP) canister purge valve electrical connector.
- Disconnect the vapor tube-to- EVAP canister purge valve quick connect coupling. For additional information, refer to QUICK CONNECT COUPLING .
- Remove the 2 bolts and the EVAP
canister purge valve.
- To install, tighten to 10 Nm (89 lb-in).
- To install, reverse the removal procedure.
- Carry out the Evaporative Emission System Leak Test. For additional information, refer to EVAPORATIVE EMISSION SYSTEM LEAK TEST .