LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Installation

Crankshaft Rear Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Using the Crankshaft Rear Main Oil Seal Installer Bolts and the Crankshaft Rear Main Oil Seal Installer, install the crankshaft rear oil seal.
    NOTE: Clean all sealing surfaces with metal surface prep.
    NOTE: Apply clean engine oil to the seal lip and seal bore before installing the seal.
    Fig 1: Installing Crankshaft Rear Oil Seal
    G06263342Courtesy of FORD MOTOR CO.
  2. Install the flexplate. For additional information, refer to Removal and Installation .
scientia non olet · About LEMON Manuals