LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Flexplate >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the transaxle. For additional information, refer to TRANSAXLE -- 3.0L .
  3. Remove the bolts and the flexplate.
    • To install, tighten to 80 Nm (59 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals