LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Crankshaft Front Seal >> Removal

Crankshaft Front Seal: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the crankshaft pulley. For additional information, refer to Removal .
  3. Using the Oil Seal Remover, remove and discard the crankshaft front seal.
    Fig 1: Removing Crankshaft Front Seal
    G06095509Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals