LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Crankshaft Pulley >> Removal

Crankshaft Pulley: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the accessory drive belt. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Remove the crankshaft pulley bolt and washer.
    • Discard the crankshaft pulley bolt.
  4. Using the 3 Jaw Puller, remove the crankshaft pulley.
    Fig 1: Identifying 3-Jaw Puller (303-D121) On Crankshaft Pulley
    G06095503Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals