LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls - Electronic Engine Controls - 3.0L (4V)) >> Removal And Installation >> Knock Sensor (KS) >> Installation

Knock Sensor (KS): Installation

WARNING: This page is about a different variant/trim than selected.

Engine block-mounted 

  1. Install the KS  and the bolt.
    • To install, tighten to 25 Nm (18 lb-ft).
  2. Connect the KS  electrical connector.
  3. Install the lower intake manifold. For additional information, refer to INSTALLATION .

    Cylinder head-mounted 

  4. Install the KS  and the bolt.
    • To install, tighten to 25 Nm (18 lb-ft).
  5. Connect the KS  electrical connector.
scientia non olet · About LEMON Manuals