LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Lower Intake Manifold >> Installation

Lower Intake Manifold: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Position the lower intake manifold and install the 8 bolts.
    • Tighten in the sequence shown to 10 Nm (89 lb-in).
    NOTE: If the engine is repaired or replaced because of upper engine failure, typically including valve or piston damage, check the intake manifold for metal debris. If metal debris is found, install a new intake manifold. Failure to follow these instructions can result in engine damage.
    NOTE: Clean and inspect all sealing surfaces. Install new gaskets.
    Fig 1: Identifying Lower Intake Manifold & Bolts In Tightening Sequence
    G06263316Courtesy of FORD MOTOR CO.
  2. Install the fuel rail. For additional information, refer to INSTALLATION .
  3. Connect the battery ground cable. For additional information, refer to REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals