Removal and Installation
WARNING:
Always disconnect the battery ground cable at the battery before disconnecting the starter motor battery terminal lead. If a tool is shorted at the starter motor battery terminal, the tool can quickly heat enough to cause a skin burn. Failure to follow this instruction may result in serious personal injury.
- Remove the battery tray. For additional information, refer to REMOVAL AND INSTALLATION .
- Remove the starter motor solenoid wire nut and position the wire aside.
- To install, tighten to 5 Nm (44 lb-in).
- Position the starter motor solenoid terminal battery cable cover aside.
- Remove the starter motor solenoid battery cable nut and position aside the cable.
- To install, tighten to 12 Nm (106 lb-in).
- Remove the 2 starter motor bolts and the starter motor.
- To install, tighten to 27 Nm (20 lb-ft).
- To install, reverse the removal procedure.