LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Engine Mechanical - 4.6L (3V)) >> In-Vehicle Servicing >> Crankshaft Rear Seal >> Removal

Crankshaft Rear Seal: Removal

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove the flywheel or flexplate. For additional information, refer to Lower End Components - Exploded View, Flexplate, Flywheel and Crankshaft Rear Seal  and Flexplate  or Flywheel .
  3. Using the special tools, remove the crankshaft oil slinger.
    • Discard the crankshaft oil slinger.
    4. Fig 1: Removing Crankshaft Rear Oil Seal Slinger
    G03920149Courtesy of FORD MOTOR CO.
  4. Using the special tools, remove the crankshaft rear seal.
    • Discard the crankshaft rear seal.
    5. Fig 2: Removing Crankshaft Rear Seal
    G03920150Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals