Normal Operation
During normal operation, the Restraints Control Module (RCM) will illuminate the air bag warning indicator continuously for approximately 6 seconds and then go out after the ignition is placed in the ON or START position and no Supplemental Restraint System (SRS) faults exist. The air bag warning indicator will remain illuminated continuously after 3 cycles of a Lamp Fault Code (LFC), if a fault exists. Refer to Air Bag and Safety Belt Pretensioner Supplemental Restraint System (SRS) . Be sure to cycle the ignition and look for an approximate 6-second indicator prove-out without LFCs.
The RCM will communicate DTCs to the scan tool through the Data Link Connector (DLC). If the scan tool displays NO COMMUNICATION when retrieving DTCs, refer to MODULE COMMUNICATIONS NETWORK article to diagnose the no communication concern.
This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- Instrument Cluster (IC) module
- RCM disconnected
- RCM