LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mariner Base, 2.5 7, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center - Instrumentation, Message Center, & Warning Chimes >> Removal And Installation >> Instrument Cluster (IC) >> Installation

Instrument Cluster (IC): Installation

  1. Position the IC, connect the electrical connector and install the 4 instrument cluster screws.
  2. Position the IC finish panel, connect the instrument panel dimmer switch electrical connector, the ambient air temperature sensor (if equipped) and install the finish panel.
  3. If installing a new IC, download the IC configuration information from the scan tool into the new IC. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
    4. NOTE: If a new IC is installed, the IC and the PCM require a parameter reset to allow the IC and the PCM to recognize each other. Failure to carry out the parameter reset to the IC and the PCM results in a no start condition.
    NOTE: The vehicles Passive Anti-Theft System (PATS) keys must be programmed to the new IC.
  4. If installing a new IC, carry out the parameter reset and key programming procedure. For additional information, refer to ANTI-THEFT - PATS - HYBRID .
scientia non olet · About LEMON Manuals