LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 551 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Interior Door Handle >> Installation

Interior Door Handle: Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the interior door handle and connect the interior door handle actuating cable.
  2. Position the interior door handle and loosely install the bolt.
  3. Install the door trim panel. For additional information, refer to REMOVAL AND INSTALLATION for front panel or REMOVAL AND INSTALLATION for rear panel. .
  4. Center the inside door handle alignment pins to the front door trim panel and tighten the interior door handle bolt to 7 N.m (62 lb-in).
scientia non olet · About LEMON Manuals