LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 571 (Interior Trim And Ornamentation) >> Removal And Installation >> Door Trim Panel - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the exterior mirror trim cover.
  2. Disconnect the exterior mirror control switch electrical connector.
  3. Remove the front door handle bezel screw cover.
  4. Remove the front door handle bezel screw.
  5. Remove the front door handle bezel.
  6. Remove the 2 front door handle trim cover screws
  7. Remove the 6 front door trim panel screws.
    8. CAUTION: Avoid pulling directly on the upper rear corner (vinyl portion) of the door trim panel during removal to prevent damage to the door trim panel.
  8. Position the front door trim panel by pulling straight away from the front door to release the retaining clips.
  9. Disconnect the power window/door lock switch electrical connector.
  10. If equipped with power memory seat, disconnect the power memory seat electrical connector.
  11. Remove the front door trim panel.
  12. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals