LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1510 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Interior Door Handle >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door trim panel. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Remove the interior door handle bolt.
    • To install, tighten to 11 Nm (97 lb-in).
  3. Disconnect the interior door handle release cable and remove the interior door handle.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals