LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1557 (Interior Trim And Ornamentation) >> Removal And Installation >> Door Trim Panel - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. Remove the front door inside handle screw cover.
  2. Remove the front door inside handle screw.

    Fusion and Milan 

  3. Remove the front door inside handle bezel screw cover.
  4. Remove the front door inside handle bezel screw.
  5. Remove the front door inside handle bezel.
    • Lift upward on the rear of the front door inside handle bezel.
    • Disconnect the electrical connector.

    All vehicles 

  6. Remove the front door trim panel upper screw.
  7. Remove the front door trim panel lower screw.
  8. Remove the front door trim panel center screw.
    • Fusion/Milan is located behind the inside door handle bezel.
    • MKZ is located above the map pocket.
  9. Remove the front door trim panel.
    NOTE: The back of the front door trim panel shown in illstration with the location of the pin-type retainers.
    • Pull the front door trim panel outward to release the pin-type retainers.
    • Disconnect the electrical connector.
    Fig 1: Identifying Front Door Trim Panel Electrical Connector
    G06271396Courtesy of FORD MOTOR CO.
  10. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals